YumengyangAuto Parts
WhatsApp Us

P0135 — O2 sensor heater circuit malfunction (bank 1, sensor 1)

OBD-II fault code · Oxygen sensor & emissions · updated 2026-11-10 · English version is the reference

P0135 is the most common oxygen sensor code there is, and the easiest to diagnose: the heater is a resistance wire, and a meter tells you the truth in thirty seconds.

What the code actually means

The heater brings the sensor up to operating temperature within seconds of a cold start. Without it the engine runs open-loop for minutes. P0135 means the heater circuit is open, shorted, or drawing a current the ECU will not accept.

Because the heater is inside the sensor body, a failed heater means a new sensor — there is no separate part. But the fuse and the supply wiring are outside, and they fail too.

What you will notice

  • Rich running and a strong smell for the first few minutes after a cold start
  • Rough cold idle that smooths as the engine warms
  • Fuel consumption higher than it should be, especially on short trips
  • Engine light on within a minute or two of starting
  • In cold climates, noticeably worse cold-start behaviour

Our order of checks

CauseOur categoryWhy it is on the list
Burnt-out heater in the sensorOxygen sensorsThe most common cause. Measured as open circuit across the heater pins.
Blown fuse—Check first. A shorted heater blows the fuse and takes the whole circuit down.
Chafed heater wire near the exhaust—Heat and vibration break the insulation and then the wire.
Corroded connector—The heater draws high current, so a bad pin heats up and fails.

Test before you buy

  1. Measure resistance across the two heater wires at the sensor connector. Open means replace the sensor.
  2. Check the fuse for that circuit.
  3. With the key on, check for battery voltage at the heater supply pin.
  4. Inspect the wiring run along the exhaust for chafe before fitting a new sensor.

The expensive mistake

Selling a sensor without checking the fuse. If the fuse is blown, the sensor is probably fine and something downstream shorted it. Two minutes with a meter decides which part the customer actually needs.

Parts we stock for a P0135

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Oxygen Sensors748Upstream sensor with heater, bank 1

Questions we get

Is the heater inside the sensor?
Yes on almost all modern sensors. A failed heater means a new sensor.
Can I drive with a P0135?
Yes. The car runs rich until it warms up, which wastes fuel but does not strand you.
How many wires does a heated sensor have?
Usually four: two for the signal, two for the heater. The heater pair is the one with the low resistance.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup