YumengyangAuto Parts
WhatsApp Us

P0230 — Fuel pump primary circuit malfunction

OBD-II fault code · Injectors & fuel delivery · updated 2026-11-10 · English version is the reference

P0230 is a no-start code. The ECU is not seeing the current it expects on the fuel pump circuit, so it does not know whether the pump is running.

What the code actually means

The ECU controls the fuel pump through a relay or directly through a driver, and monitors the circuit. An open circuit, a short, or a current that is far out of range sets P0230.

On many cars the pump primes for two seconds at key-on and then runs only while the ECU sees rpm. So a pump that is silent at key-on is not automatically dead — check whether the circuit is being commanded at all.

What you will notice

  • Cranking with no start, and no pump prime sound at key-on
  • An engine that starts then dies within a second or two
  • A stall at speed followed by a no-start
  • Sometimes an intermittent no-start that resolves itself when the car cools

Our order of checks

CauseOur categoryWhy it is on the list
Failed fuel pumpFuel pumpsWorn brushes and a seized impeller. The usual end of the line.
Fuel pump relay—Cheap, common and easy to swap. Always check it before ordering a pump.
Blown fuse or inertia switch—An inertia cut-off after a bump looks exactly like a dead pump.
Corroded pump connector at the tank—Very common on cars from humid regions. The plug overheats and the current drops.
Bad earth to the pump—The circuit is complete enough to read voltage but cannot carry current.

Test before you buy

  1. Listen for the prime at key-on. No sound, then check the relay and fuse before the pump.
  2. Measure voltage at the pump connector while cranking. Battery voltage there condemns the pump; near zero condemns the circuit.
  3. Check the pump earth with a voltage drop test, not a continuity test.
  4. If voltage is good and the pump still does not run, the pump is the answer.

The expensive mistake

Replacing the pump when the relay or the tank connector was the fault. The new pump runs for a while on the same marginal circuit and then the code returns. Voltage at the connector while cranking is the test that separates the two, and it takes one minute.

Parts we stock for a P0230

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Fuel Pumps780Fuel pump — after the circuit checks out
Fuel Pressure Regulators4Check pressure once it runs

Questions we get

Will a bad relay cause P0230?
Yes. The ECU monitors the circuit and a relay that does not close is an open circuit.
Can I drive with a P0230?
Only until the pump stops. This is a no-start code that usually becomes a tow.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup