YumengyangAuto Parts
WhatsApp Us

P0105 — Manifold absolute pressure circuit malfunction

OBD-II fault code · Air metering & mixture · updated 2026-11-10 · English version is the reference

P0105 is the MAP sensor's no-signal code. On speed-density engines it is as important as the MAF, and on some cars a failed MAP sensor is the reason the engine will not start at all.

What the code actually means

The MAP sensor reports manifold pressure, which the ECU converts into air mass. No usable signal, or a signal outside the electrical range, sets P0105. On engines with both MAF and MAP, the MAP is mostly a plausibility check and a boost reference.

Where the sensor takes its vacuum matters. A blocked or leaking reference port reads atmospheric pressure all the time, which looks like a sensor fault on the scanner but is not.

What you will notice

  • Poor idle quality and a hunting idle
  • Excessive fuel consumption and black smoke
  • Hard starting or a no-start on speed-density engines
  • A turbo car with no boost or boost limited to a safe value
  • Altitude-related running problems if the reference port is blocked

Our order of checks

CauseOur categoryWhy it is on the list
Failed MAP sensorIntake pressure sensors (MAP)Most common, and easy to test with a hand vacuum pump.
Blocked or split vacuum reference hose—The sensor is fine; it is not seeing manifold vacuum. Check this first.
Oil or carbon in the sensor port—Especially on engines with a lot of blow-by. Clean it before replacing it.
Loom damage—The sensor is usually mounted on the manifold where heat and vibration are worst.

Test before you buy

  1. Read MAP with the key on, engine off: it should read close to atmospheric. If it does not, the sensor or the reference is wrong.
  2. Apply vacuum with a hand pump and watch the reading change smoothly. A dead spot or a stuck value condemns the sensor.
  3. Check the reference hose for cracks and for blockage.
  4. Compare KOEO and idle readings — the difference tells you whether the sensor is seeing vacuum at all.

The expensive mistake

Replacing the MAP sensor when the vacuum hose to it is blocked with carbon. The new sensor reads the same wrong pressure. Pull the hose off and blow through it before you order.

Parts we stock for a P0105

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Intake Pressure Sensors (MAP)113Intake pressure sensor (MAP)
Mass Air Flow Sensors73Cross-check airflow on engines with both

Questions we get

Can a bad MAP sensor stop the engine starting?
On speed-density engines, yes — the ECU has no other way to calculate fuel.
What does the MAP sensor read with the engine off?
Atmospheric pressure, roughly 100 kPa at sea level. A very different value means the sensor or its reference is wrong.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup