YumengyangAuto Parts
WhatsApp Us

P0122 — Throttle position sensor A circuit low input

OBD-II fault code · Temperature, idle & throttle · updated 2026-11-10 · English version is the reference

P0122 is an electrical fault in the throttle position circuit: the signal is lower than it should be for the throttle angle. It is the low-voltage twin of P0120.

What the code actually means

The TPS output voltage has fallen below the minimum expected. That can be a worn resistive track at the closed-throttle end, a bad earth, or a partly broken signal wire.

Because the ECU uses this signal to know when the throttle is closed, a low reading confuses idle control, fuel cut-off on overrun and the gearbox shift logic all at once.

What you will notice

  • A high or hunting idle
  • Hesitation when pulling away
  • Poor gearbox behaviour on automatics
  • Reduced power and a possible limp mode
  • Sometimes the engine cutting out on deceleration

Our order of checks

CauseOur categoryWhy it is on the list
Worn TPS resistive trackThrottle position sensorsThe track wears at the closed position where the wiper sits most of its life.
Bad earth—Shifts the whole signal down. Check it before the part.
Chafed signal wire—A partly broken wire drops voltage under vibration.
Dirty throttle bodyThrottle bodiesCarbon stops the plate closing fully, so the sensor reads below its learned zero.

Test before you buy

  1. Watch the TPS voltage at closed throttle and compare with the specification.
  2. Sweep the throttle and look for dips — a worn track shows as a momentary drop.
  3. Check the earth with a voltage drop test.
  4. Clean the throttle body and perform the relearn before replacing the sensor.

The expensive mistake

Replacing the TPS because the plate is carboned up and cannot reach its closed position. The new sensor learns the same wrong zero. Clean first, relearn, then judge.

Parts we stock for a P0122

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Throttle Position Sensors42Throttle position sensor
Throttle Bodies438Body where the sensor is integrated

Questions we get

What is the difference between P0120 and P0122?
P0120 is a general circuit failure. P0122 is specifically a signal that is too low.
Can a low TPS signal cause a high idle?
Yes. The ECU cannot tell the throttle is closed, so it holds the idle speed up.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup