P0201 — Injector circuit / open — cylinder 1
P0201 is a circuit code, not a mixture code. The ECU is telling you cylinder 1's injector does not have the electrical signature it expects — which is often the loom, not the injector.
What the code actually means
The ECU fires each injector and monitors the current through its winding. An open circuit, a short, or a driver stage that does not switch correctly sets P0201 for cylinder 1.
Because it is a cylinder-specific circuit code, it is a gift: it names the cylinder. The work is deciding whether the fault is the injector, the harness or the ECU driver.
What you will notice
- A dead miss on cylinder 1 that does not improve with revs
- Strong fuel smell if the injector is stuck open
- A no-start or a very rough start on some engines
- Cylinder 1 misfire code alongside P0201 in most cases
Our order of checks
| Cause | Our category | Why it is on the list |
|---|---|---|
| Failed injector winding | Fuel injectors | Open or shorted coil in the injector. Measured with an ohm meter. |
| Chafed or broken injector harness | — | The loom runs along the head where it is hot and where it rubs. |
| Corroded connector pins | — | Very common on older engines and in humid climates. |
| ECU driver stage | — | If a new injector sets the same code immediately, the driver is gone. |
Test before you buy
- Measure injector resistance and compare with another cylinder. A reading far outside the group is the answer.
- Listen to the injector with a stethoscope or a long screwdriver while cranking. Silence means it is not firing.
- Swap the coil pack or check the signal with a noid light — the light confirms the driver, not just the injector.
- Check the loom where it bends near the head before ordering anything.
The expensive mistake
Shipping an injector for a car with a broken loom. If the new injector sets P0201 again straight away, the circuit is the fault. Ask for the resistance reading of the old injector before you ship — it costs the customer two minutes and saves you a return.
Parts we stock for a P0201
Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.
| Our category | Part numbers | When |
|---|---|---|
| Fuel Injectors | 168 | Cylinder 1 injector |
Questions we get
Can I drive with a P0201?
How do I test an injector without a scanner?
Contact
广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.
E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China
Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.