YumengyangAuto Parts
WhatsApp Us

P0303 — Cylinder 3 misfire detected

OBD-II fault code · Misfire & ignition · updated 2026-11-10 · English version is the reference

P0303 on a four-cylinder is usually ignition. On a V6 it is often the cylinder hiding under the intake plenum, which is why the labour is what the customer is really complaining about.

What the code actually means

Cylinder 3 is not producing its share of torque. The ECU flags it after comparing crankshaft acceleration with the other cylinders on two consecutive trips. Nothing in the code tells you whether the cause is spark, fuel, air or compression — that is your job.

On V6 engines cylinder 3 is frequently on the bank under the intake manifold. If a garage is going to remove the plenum to reach one coil, they will usually ask for all three coils on that bank — quote accordingly.

What you will notice

  • Rough idle and a vibration you can feel through the seat at low speed
  • A hesitation when pulling away, then normal running above 2,500 rpm
  • Occasional backfire into the intake on a cold engine
  • Fuel consumption climbing over a few weeks rather than overnight
  • P0303 plus P0300 together — random misfire with one dominant cylinder

Our order of checks

CauseOur categoryWhy it is on the list
Coil on cylinder 3Ignition coilsOn coil-on-plug engines this is the first and most common answer.
Spark plug, especially on LPG or CNG conversionsSpark plugsGas conversions eat plugs faster and misfire on one cylinder first.
Plug wire set on older wasted-spark enginesSpark plug wire setsCylinder 3 and 4 wires often share a route past the exhaust and cook together.
Valve clearance or compression—Cylinder 3 runs hottest on many inline fours. Burnt valves show up here first.

Test before you buy

  1. Swap coil 3 with coil 1, clear codes, drive. Where the misfire goes, the fault goes.
  2. Do a compression or leak-down test if the misfire stays on 3 with known-good ignition.
  3. On gas-converted cars, check the plug gap — gas likes a wider gap than petrol and the conversion installer rarely adjusts it.
  4. Check the coil connector for corrosion: cylinder 3 on transverse engines sits where water from the windscreen scuttle runs.

The expensive mistake

Assuming a compression problem from one bad leak-down reading on a cold engine. Rings seal better hot. If the misfire only appears hot and the compression test is done cold, you will quote an engine job for a coil.

Parts we stock for a P0303

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Ignition Coils544Cylinder 3 coil
Spark Plugs141Change with the coil
Spark Plug Wire Sets182Wasted-spark engines

Questions we get

Why does cylinder 3 fail more often?
On many inline fours it is the hottest cylinder and the one where coolant flow is weakest, so plugs and coils age faster there.
Should I replace one coil or the set?
One, if the others test good. On high-mileage engines quote the set and let the customer choose — it is their labour that decides, not the part price.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup