YumengyangAuto Parts
WhatsApp Us

P0304 — Cylinder 4 misfire detected

OBD-II fault code · Misfire & ignition · updated 2026-11-10 · English version is the reference

P0304 is the last cylinder on most inline fours and the one nearest the gearbox — which means the coil is often the easiest to reach and the wiring the most likely to be chafed.

What the code actually means

The ECU has decided cylinder 4 contributes less than the rest. It compares crankshaft acceleration per firing event and stores P0304 after two consecutive drive cycles show the same shortfall. The code names the cylinder; it does not name the cause.

On engines numbered from the flywheel end, cylinder 4 is at the timing end instead. Confirm the numbering from the firing order before you quote, or the customer fits the coil in the wrong place and the fault does not move.

What you will notice

  • A steady shake at idle, worse when cold, that mostly clears above 2,000 rpm
  • Hesitation when accelerating from a standstill
  • A flashing light under load, steady light at cruise
  • Slightly rough running right after a service — often a plug that was gapped wrong
  • P0304 with P0172 means that cylinder is running rich, usually a leaking injector

Our order of checks

CauseOur categoryWhy it is on the list
Coil on cylinder 4Ignition coilsFirst suspect on coil-on-plug engines and the cheapest to test by swapping.
Spark plugSpark plugsWrong gap after a service is a real and common cause — ask when the plugs were last changed.
Chafed coil harness at the gearbox end—On transverse engines the loom to cylinder 4 runs close to the bell housing and rubs through.
Leaking injectorFuel injectorsShows as a rich code on that bank and a misfire that clears when the engine is hot.

Test before you buy

  1. Swap the coil to another cylinder and clear. Fastest test there is.
  2. Wiggle the coil connector and the loom while watching live misfire counters — if the count jumps, the fault is the harness, not the part.
  3. Check the plug gap with a gauge. Do not trust "they were changed last month".
  4. If everything checks good, run a relative compression test through the scanner before condemning the engine.

The expensive mistake

Quoting a coil when the loom is chafed. The new coil works for a week, then the vibration rubs the same wire through again and the part comes back marked "defective". Ask for a photo of the connector and the loom before shipping.

Parts we stock for a P0304

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Ignition Coils544Cylinder 4 coil
Spark Plugs141Check the gap first
Fuel Injectors168When the bank runs rich

Questions we get

Is P0304 serious?
It is as serious as any single-cylinder misfire: it costs fuel, it damages the catalyst over time, and it will not fix itself.
Can a bad plug cause P0304 only?
Yes. One plug can fail while the other three are fine, especially after a service where the gap was set wrong.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup