YumengyangAuto Parts
WhatsApp Us

P0340 — Camshaft position sensor A circuit malfunction

OBD-II fault code · Crank, cam & timing · updated 2026-11-10 · English version is the reference

P0340 usually does not stop the engine, it makes it start badly. Without the cam signal the ECU cannot tell compression from exhaust stroke, so it guesses — and guessing costs cranking time.

What the code actually means

The camshaft position sensor tells the ECU which stroke each cylinder is on. The crank sensor gives position but is ambiguous by one revolution, so the ECU needs the cam signal to fire in the right order. When that signal is missing, P0340 is set.

Most engines will still run on the crank signal alone using a default strategy, which is why this code often comes with long cranking rather than a no-start. VVT engines are the exception and may refuse to start or run very badly.

What you will notice

  • Longer cranking than normal, sometimes several seconds, then a start
  • A rough idle for the first seconds after start
  • Poor acceleration and a loss of VVT function on engines with variable timing
  • The light on with otherwise acceptable running
  • On some cars a P0016 appears alongside it

Our order of checks

CauseOur categoryWhy it is on the list
Failing camshaft position sensorCamshaft position sensorsThe most common cause, and the sensor most likely to fail with heat.
Oil or sludge on the sensor face—A sensor buried in sludge reads nothing. Clean it before replacing it.
Timing chain or belt jumped—The cam signal arrives at the wrong time and the ECU flags the circuit.
Loom damage—The cam sensor wire runs along the head, which is hot and full of vibration.
Wrong sensor fitted previouslyCamshaft position sensorsHall and inductive sensors are not interchangeable, and the connectors often look alike.

Test before you buy

  1. Clear the code and see whether it comes back immediately or after a drive cycle. Immediate return means a hard electrical fault.
  2. Check the sensor type and the connector — Hall sensors need a supply, inductive ones do not.
  3. Remove the sensor and look for metal debris or sludge on the face.
  4. If the sensor is good, check the cam timing marks before ordering anything else.

The expensive mistake

Not distinguishing P0340 from P0016. P0340 is the circuit; P0016 is the correlation between crank and cam. If both are present, the timing is suspect and a new sensor will not fix it.

Parts we stock for a P0340

Stocked numbers and fitment for these categories are in the catalogue; message us with the car details and we will pick the right one.

Our categoryPart numbersWhen
Camshaft Position Sensors159Camshaft position sensor — check the type
Oil Control Valves183On VVT engines, check the oil control valve too
Crankshaft Position Sensors236Compare crank signal

Questions we get

Can I drive with a P0340?
Usually yes, but starting gets worse and VVT engines may run badly. Fix it before it strands the car.
Why does the car crank longer with a P0340?
The ECU has to guess the stroke, so it tries combinations until it finds one that fires.

Contact

广州驭盟扬汽配 · Guangzhou Yumengyang Auto Parts Co., Ltd.

E05, Yiyou (Guangyuan East) Auto Parts City, Baiyun District, Guangzhou, China

Send us the code, the car and the year. If this page points at several parts, we will tell you which one to change first — and which one not to change.

WhatsApp +86 159 1585 9048 OE / cross-reference lookup